Lenovo Flex 2 Pro-15 Hardware Maintenance Manual page 60

Lenovo Flex 2 Pro-15/Edge 15 Hardware Maintenance Manual
Figure 15. Removal steps of LCD panel and LCD sensor board (continued)
d
Turn the LCD panel by arrow to make sure the touch board visible. Unplug
e
the connector from the sensor board by arrow . Disconnect the two connector
7
f
by arrows .
4
7
6
5
h
Turn the LCD panel over by arrow . Peel off the tape of the eDP connector and
i j
disconnect it by arrow , then remove the LCD panel by arrow .
8
10
9
When installing: Make sure that the LCD connector and touch connector are
attached firmly.
56