Checking The Water Dispenser Line - Samsung Refrigerator User Manual

CHECKING THE WATER
DISPENSER LINE
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that.
In order for the icemaker to operate properly, water
pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be fi lled in 10
seconds.
If the refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.
Make sure the water storage tank inside the
refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water Line installation Kits are included with
unit. You can fi nd it in freezer(or fridge) drawer.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
Parts for water line Installation
1 Water line fixer Water line fixer 2 Pipe connector Pipe connector
and screws and screws
4 Clip Clip
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifier to malfunction.
16_ setting up
3 Water line Water line
5 Water Filter Water Filter
Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
4. After connecting the water supply to the water
filter, turn your main water supply back on and
Dispense about 3L to clear and prime the water
filter.
INSTALLING THE WATER
DISPENSER LINE
Connecting the water line to the
refrigerator
1. Remove the cap from water line on the unit and
insert compression nut to the water line on the
unit after disassembling from provided water line.
2. Connect both water line from the unit and water
line in the kit
3. Tighten the compression nut onto the
compression fitting. Be careful no gap between
two items.
4. Turn water on and check for any leakage.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
Water Line Water Line
from Kit from Kit
No gap No gap
No gap No gap