Craftsman 315.115160 Operator's Manual page 21

POSITIVE 0° BEVEL STOP
See Figure 25.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
90° cuts.
TO CHECK POSITIVE 0° BEVEL STOP
Follow these directions to check the positive 0° bevel
stop:
n Remove battery pack from your trim saw.
WARNING:
Failure to remove battery pack from
the tool could result in accidental starting causing
serious injury.
n Place the saw in an upside down position on a work-
bench.
n Check the squareness of the saw blade to the base of
the saw using a carpenter's square.
TO ADJUST POSITIVE 0° BEVEL STOP
Follow these directions to adjust the positive 0° bevel
stop:
n Remove battery pack from your trim saw.
WARNING:
Failure to remove battery pack from
the tool could result in accidental starting causing
serious injury.
n Loosen bevel adjustment knob.
n Turn setscrew with hex key and adjust base until it is
square with the saw blade.
n Tighten bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having
the bevel adjustment knob securely tightened can
result in serious injury.
OPERATION
ADJUSTMENT
SCREW
HEX NUT
POSITIVE 0°
BEVEL STOP
CARPENTER'S
SQUARE
21
BEVEL
ADJUSTMENT
KNOB
BLADE
Fig. 25