Adsl Wan Connections - D-Link DSL-6740U User Manual

DSL-6740U VDSL/Ethernet Router with Wi-Fi
and Built-in Switch
User Manual
11. Go to the Advanced / Interface grouping page.
12. Create a group containing the WAN connection of the Bridge type and the LAN 2 port.
13. Create another group containing the WAN connection of the Dynamic IP type, the LAN 3
port, and the wireless interface.
14. Save the router's settings.

ADSL WAN Connections

In some cases, it is necessary to assign two WAN connections (of the Bridge/Static IP/Dynamic IP
type) to one virtual channel (that is, to specify the same values of the VPI/VCI).
For example, your ISP provides the IPTV service (VPI = 0, VCI = 35). You need to configure a
WAN connection of the Bridge type for the set-top-box connected to the LAN 2 port of the router
and a WAN connection of Dynamic IP type for the computer connected to the LAN 3 port of the
router and the laptop connected to the wireless interface of the router.
To configure the router, follow the steps below:
1. Go to the Net / WAN page and click the Add button.
2. Select the Bridge value from the Connection Type drop-down list.
3. Select the DSL(new) value from the Interface drop-down list.
4. Fill in the VPI and VCI fields.
5. In the VLAN section, select the Allow to create several connections assigned to
this port checkbox.
6. Click the Save button.
7. Click the Add button again.
8. Select the Dynamic IP value from the Connection Type drop-down list.
9. Select the atm1(0/35) value from the Interface drop-down list.
10. Click the Save button.
Figure 113. Two WAN connections with the same values of the VPI and VCI.
Figure 112. Groups of ports for the created WAN connections.
Page 154 of 158
Operation Guidelines