Maytag Neptune MAH9700 User Manual page 23

Slide 43
Water flow through dispenser during Wash fill
HOT
WATER
V #4
Path #3 Path #4
FILL /
DRAIN (HEATING)
Rotation of
Spinner
COLD
First minute of fill with no water in tub
WATER
Valve #3 opens and cold water flows through path #3 to detergent
V #1 compartment (Pre wash)
V #3
To specified Water Level (Final Water Level) for each cycle
1. If ATC (warm or cold) is selected,
V #2
Valves #1 and #4 open as needed to achieve specified water
Path #2 Path #1
temperature. Cold water flows through path #1 and hot water
through path #4 to the detergent compartment
2. If NON-ATC is applied,
If "HOT wash" is selected, valve #4 opens and water flows through
path #4.
If "COLD wash" selected , Valve #1 opens and cold water flows
through path #1
Cold wash and rinse, Non ATC: water temperature shall be tap cold
Cold wash, ATC: water temperature of 65°F±10°F
Warm wash, ATC: water temperature of 105°F±10°F
Warm Rinse, ATC: water temperature of 80°F±10°F
for final rinse only, all other rinses will be "tap cold"
Hot Wash, Non ATC: water temperature shall be tap hot
WASH
COOLING /
WASHING
DISENTANGLE
19
SUB
TOTAL
(Reset Level – 25.6 kHz)