Warning Light (Insufficient Oil Pressure) (03_02; Engine Oil Change - PIAGGIO Beverly 250 i.e. User Manual

Hide thumbs Also See for Beverly 250 i.e.:
Table of Contents

Advertisement

Warning light (insufficient oil pressure) (03_02)

The scooter is equipped with a warning light "I" that lights up when the key is turned
to the "ON" position.
However, this light should switch off once the engine has been started.
If the light comes on during braking, at idling speed or while turning a corner,
it is necessary to check the oil level and top-up if required. If after having topped
up the oil, the warning light still turns on while braking, at idle speed or while
turning a corner, it will be necessary to turn to an Authorised Service Centre.
03_02

Engine oil change (03_03, 03_04)

The oil and cartridge filter "C" must be changed after 1,000 km and every 10,000 km
at an authorised Piaggio service centre. The engine should be emptied by draining
the oil from the drainage cap "B" of the gauze filter on the flywheel side. In order to
facilitate the oil drainage, loosen the cap/dipstick. Since a certain quantity of oil re-
mains in the circuit still, the top-up should be carried out with around 600 ÷ 650 cc of
oil from cap "A". Then start up the scooter, leave it running for a few minutes and
switch it off: after five minutes, check the level and if necessary top up without ex-
ceeding the MAX. level. The cartridge filter must be replaced at every oil change.
For top up and change, use new oil of the recommended type.
03_03
WARNING
RUNNING THE ENGINE WITH INSUFFICIENT LUBRICATION OR WITH INADE-
QUATE LUBRICANTS ACCELERATES THE WEAR AND TEAR OF THE MOVING
PARTS AND CAN CAUSE IRRETRIEVABLE DAMAGE.
03_04
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents