Note: Ensure that the bail will reach the handle
after the transmission is engaged.
Figure 31
1. Lower nut
4. Adjust the reverse speed stop as follows:
•
Loosen the 2 nuts on the reverse speed stop
(Figure 32).
•
Move the stop down to the midpoint or slightly
past it and tighten the 2 nuts (Figure 32).
Note: The reverse speed should be around 3.2
km/h (2.0 MPH).
1
Figure 32
1. Nuts
Tine Maintenance
Checking/Replacing Tines
Service Interval: Before each use or daily
1. Raise the tines, stop the machine, stop the engine, and
2. Remove the rear access panel; refer to
3. Manually rotate the tines on the shaft, inspecting them
4. If any are damaged or broken, remove the nut and bolt
1
G020485
1. Tine assembly
2. Tine
5. Remove the tine and replace it with a new one. Ensure
6. Secure the new tine with the bolt and nut you removed
7. When all tines have been inspected and replaced as
G020486
21
disconnect the spark plug wire.
Accessing the Tines (page 13)
for wear or damage.
securing the tine to the tine assembly (Figure 33).
Figure 33
that the new tine is facing the same direction as the
other tines on the assembly.
previously and torque them to 30 ft-lb (40.6 N-m).
needed, lower the machine to the ground and engage
the hydrostatic drive.
3. Bolt and nut