Page 3
Read and understand all instructions before using. Do not operate any device if it has been dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
Page 6
Made in the greater Minneapolis/St. Paul metropolitan area, New Hope, Minnesota, USA. System Connectivity Example 1: Basic system connectivity of a Vaddio WallVIEW™ HD-18 and Quick-Connect DVI/HDMI - SR Interface with Vaddio ProductionVIEW™ Precision Camera Controller and Monitors WallVIEW HD-18...
Page 7
*Simulated Video Feeds General Installation Instructions: Like all Vaddio Cat 5e cabling systems, the Quick-Connect DVI/HDMI - SR is easy to install and operate. The HD-18 product was specifically designed with Cat 5 cable connectivity for Power, Video and Control/IR signaling and only two Cat 5 cables are required from the Quick-Connect camera. Installation is simplified in that no custom 8-Pin mini-din cables or expensive multi-core plenum cables are needed and no power outlets are required near the camera bracket.
Page 8
Connect the 2 Cat 5e cable from the RS-232 CONTROL “TO CAMERA” port to the RS-232 IN/IR OUT jack on the back of the HD-18 camera. Connect the control source (i.e. Vaddio’s Precision Camera Controller, ProductionVIEW HD, ControlVIEW™ XHD, AutoPresenter™...
Page 10
Depending on the codec that is used, and which RS-232 port is used with a codec, special DB-9 to RJ-45 adapters may sometimes be required. Refer to Vaddio’s price list or website for Tech Notes on the HD- 18 page on specific diagrams for wiring the camera to videoconference codecs.
Page 11
This device must accept any interference including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority to operate this equipment. ICES-003 Compliance This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Page 12
This device must accept any interference including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority to operate this equipment. ICES-003 Compliance This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Page 13
Vaddio Customer service – Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty and is found to be defective. If the product is out of warranty, Vaddio will test then repair the product or products.
Need help?
Do you have a question about the WallVIEW HD-18 DVI/HDMI and is the answer not in the manual?
Questions and answers