10-6) Key Scan And Display Circuit - Samsung RS2534WW Service Manual

Circuit Descriptions

10-6) Key Scan and Display Circuit

1) Key Scan and display operation.
Note)
1) F-DEF-sensor and Bimetal work in parallel.
2) At the first power on, an open error (5V input to
MICOM) can be detected by self-diagnostics. A
short error will be ignored.
3) In self-diagnostics during a normal operation, only
an open error can be detected.
4) The F-DEF heater will be off at the set temperature
after the bimetal is off.
The model uses a decorder IC which 4 inputs and 9 outputs.
If the IC 9 decorder (TC4028BP) receivesd signals from
MICOM pins (3∼6), an output signal per 2 miliseconds
comes out from Q3, Q41, Q8, Q6, Q9, Q7, Q0, Q2, and Q4
pin in sequence. This signal enters to a driver IC input
terminal of the CoolSelect Zone
62783AP), then approximate 11V peaks will generate from an
output terminal as shown on the next page.
40
TM PCB and IC5 (TD