Mounting Instructions - scope Tactic ET10 Operating And Installation Instructions

Mounting Instructions

The heater is fixed on the wall with the mounting bracket attached to the
back of heater.
To secure mounting bracket to the wall
1. Remove the wall mounting bracket from the back of the heater,
by compressing the bayonet fittings at the top and/or sides of the
bracket, which clip into the heater body (see figure 2 below).
2. Place the mounting bracket against the wall, ensuring the bracket
is level and the minimum distance between the heater and the
adjacent surfaces are adhered to (see table 2 on page 9).
3. Mark and drill the fixing holes at the top and bottom of the
mounting bracket, and attached to the wall with suitable screws
and/or wall anchors (see figure 3 on page 9).
4. Locate the heater over the bottom clips of the wall bracket and
then push the heater securely into the bayonet fittings on the top
and/or sides of the bracket.
To remove heater from the wall
1. By using a pointed tip screwdriver, push in and lever out the
bayonet fittings at the top and/or sides of wall mounting bracket
(see figure 2 below).
2. Lift the heater up and away from the wall.
Lever OUT
Push IN
8
Wall mounting bracket removed from heater
Heater body
Figure 2: Wall Mounting Bracket Fitting
Wall mounting bracket
Heater body
TACTIC.ET10, ET15 and ET20
SKOPE Airelec Convection Panel Heaters
Bayonet
fitting