scope Tactic ET10 Operating And Installation Instructions

scope Tactic ET10 Operating And Installation Instructions

Skope airelec tactic horizontal convection panel heaters

Advertisement

SKOPE Airelec
TACTIC
Horizontal Convection Panel Heaters

Advertisement

Table of Contents
loading

Summary of Contents for scope Tactic ET10

  • Page 1 SKOPE Airelec TACTIC Horizontal Convection Panel Heaters...
  • Page 3 Introduction When purchasing a SKOPE product, our customers put trust in us to deliver upon a promise. They expect their SKOPE heater or refrigerator to be, amongst other things, a totally dependable high performer, features that capture and illustrate the key values that guide us as a company.
  • Page 4: Safety Information

    Safety Information When using any electrical appliance, safety precautions should always be observed. Read these instructions carefully, and retain for future reference. • When used by, or near, young children or infirm persons, close supervision is necessary. Young children should be supervised to ensure that they do not play with the appliance.
  • Page 5: Safety Cut-Out

    Safety Cutout Your SKOPE Airelec convection heater is fitted with an auto-reset thermal cutout. This safety device will automatically switch off the elements should the heater reach an abnormal temperature. Should this occur: switch off the heater immediately, and disconnect from the power supply.
  • Page 6: Control Settings

    Control Settings OPERATION Switch Dial: GREEN = Stand-by - Turn dial to right RED = Power ON - Turn dial to left Thermostat 1 ~ 9 Thermostat setting Dial: Freeze Guard: 7°C (approx.) Table 1: Control Settings GREEN = Stand-by 1~9 = Thermostat RED = Power ON S = Freeze Guard...
  • Page 7: Installation

    Installation This appliance must be installed in accordance with the relevant elec- trical wiring rules and regulations. The heater must not be located immediately below a socket-outlet. A suitable disconnection device (acting in all active supplies) is required to be incorporated in the fixed supply wiring.
  • Page 8: Mounting Instructions

    Mounting Instructions The heater is fixed on the wall with the mounting bracket attached to the back of heater. To secure mounting bracket to the wall Remove the wall mounting bracket from the back of the heater, by compressing the bayonet fittings at the top and/or sides of the bracket, which clip into the heater body (see figure 2 below).
  • Page 9: Installation Dimensions

    Installation Dimensions Read the following dimensions in conjunction with figure 3 below. DIMENSIONS TACTIC ET10 234mm 200mm 112mm 94mm TACTIC ET15 248mm 200mm 138mm 214mm TACTIC ET20 405mm 200mm 221mm 214mm SKOPE Industries Limited reserve the right to alter specifications without notice.
  • Page 10 Limiting the Thermostat Dial The thermostat dial can be adjusted so as to limit the maximum and minimum temperatures, or locked at a fixed temperature position. Limiting to a maximum temperature Twist out one of the plastic pins from back of the thermostat dial (see figure 4 on page 11).
  • Page 11: Specifications

    Specifications MODELS Wattage Height Width Depth TACTIC.ET10 900-1000 W 400mm 440mm 105mm TACTIC.ET15 1400-1500 W 400mm 600mm 105mm TACTIC.ET20 1800-2000 W 400mm 840mm 105mm ELECTRICAL Supply: 230-240 Volts a.c. 50 Hz, single phase Wiring: 1.8 metre 2-core flex and plug, with the following polarity: Phase = Brown, Neutral = Blue Double Insulated Table 3: Specifications...
  • Page 12: Contact Addresses

    Contact Addresses New Zealand SKOPE INDUSTRIES LIMITED PO Box 1091, Christchurch New Zealand Freephone: 0800 947 5673 Fax: (03) 983 3896 Email: enquiry@skope.co.nz Website: www.skope.co.nz Australia SKOPE AUSTRALIA PTY LTD A.C.N. 000 384 270 PO Box 7543, Baulkham Hills B.C. NSW 2153, Australia Freephone: 1800 121 535 Freefax: 1800 121 533...

This manual is also suitable for:

Tactic et15Tactic et20

Table of Contents