Abit SE6 User Manual page 58

3-28
available: Button Only ) Keyboard 98 ) Hot Key ) Mouse Left ) Mouse Right.
Default setting is Button Only.
The mouse wake up function can only be used with the PS/2 mouse, not with a mouse
that uses the COM port and USB connection. Mouse Left (Mouse Right) means you
need to double click the mouse left (right) button, for the computer to power on. You
also need to note the compatibility issue with your PS/2 mouse. Some PS/2 mice cannot
wake up the system because of compatibility problems. Also, if the specs of your
keyboard are too old, it may fail to power on.
KB Power ON Password:
This option allows you to set a password required in order to Power ON your computer.
You will be asked to enter your password and then to confirm it. Do not forget your
password. Should you forget your password, you will have to open your computer case,
clear the CMOS and reset all parameters again in order to be able to utilise this function.
Hot Key Power On:
There are twelve options are available, Ctrl-F1 to Ctrl-F12. You can select this item and
using the Ctrl plus the one of each function key (F1 to F12) to power on the computer.
The default setting is Ctrl-F1.
Onboard FDC Controller:
Two options are available: Enabled and Disabled. The default setting is Enabled. You can
enable or disable the onboard FDD controller.
Onboard Serial Port 1:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available:
Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) AUTO. The default
setting is 3F8/IRQ4.
Onboard Serial Port 2:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available:
Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) AUTO. The default
setting is 2F8/IRQ3.
SE6
Note
Chapter3