Abit SE6 User Manual page 23

Installing the Motherboard
PN1 (Pin 1-2-3-4-5): Power LED Headers
the wrong direction, the power LED light will not illuminate correctly.
Note: Watch the power LED pin position and orientation.
PN1 (Pin 7 - 8): HDD LED Header
Note: Watch the HDD LED pin position and the orientation.
PN1 (Pin 10 - 11): Power on Switch Header
PN1 (Pin 13-14): Hardware Suspend Switch (SMI Switch) Header
Note: If the ACPI function in the BIOS setup is enabled, this function will not work.
There is a specific orientation for pins 1
through 3. Insert the three-threaded power
LED cable to pins 1~3. Check to make sure
the correct pins go to the correct connectors
on the motherboard. If you install them in
Attach the cable from the case's front panel
HDD LED to this header. If you install it in
the wrong direction, the LED light will not
illuminate correctly.
Attach the cable from the case's front panel
power switch to this header.
Attach the cable from the case's front panel
suspend switch (if there is one) to this
header. Use this switch to enable/disable the
power management
hardware.
2-13
function through
User's Manual