Timer Mode - GLOBAL ASSISTIVE DEVICES VibraLITE 8 User Manual

To Stop the Counting, Push the START/STOP Button.
Pushing the START/STOP Button again will start the stopwatch counting
from where it stopped.
To reset the stopwatch to zero while running, push the START/STOP Button
and then push the LAP/RESET Button.
To reset to zero when stopped, push the LAP/RESET Button.
Split timing on Stopwatch
Start the Stopwatch by pushing the START/STOP Button. The stopwatch
will start counting up.
Push the LAP/RESET Button. The watch will continue counting even
though you do not see it on the display. The Icon at the top of the display
will continue to flash to show action and that counting continues.
Push the LAP/RESET Button again and the display will change and show
the time that has accumulated in total.
To reset the stopwatch to zero, push the START/STOP Button and then
push the LAP/RESET Button.

TIMER MODE

can be set for countdown in Hours, Minutes and Seconds. Timer can be set
for any amount of time up to 23 Hours, 59 minutes and 59 seconds. Note: If
hours or minutes or seconds are not wanted on countdown, leave at 0
during setting.
A 5 second alert will be activated when countdown reaches zero. If the time
set is less than 30 seconds, the alert will be only 1 second.
Having the Countdown Time Continually Repeating automatically is an
option. .
Having a reminder before zero on the countdown is an option that can also
be set. The reminder alert is one second.
SETTING TIMER FOR COUNTDOWN
Push MODE Button to rotate to TIMER MODE.
Push and Hold LAP/ RESET Button. HOLD TO SET will
be show on the display. Hold for 3 seconds. Hour digit will
flash.
Push START/STOP Button to rotate to desired hours of
time wanted.
Vibra LITE 8 is a trademark of GLOBAL ASSISTIVE DEVICES, INC. Page 7