Variable Speed; Brake; Gear Ratio Selector; Torque Adjustment Collar - Black & Decker KC1261 Manual

VARIABLE SPEED

change in speed is controlled continuously using the
trigger switch or in two stages using the gear ratio
selector. The maximum speed achieved using the trigger
switch depends on the gear ratio selector setting.

BRAKE

The brake switch stops the rotation of the chuck in
less than 1 second. This feature is useful when
adjusting the seating of screws, and for driving
quickly a large number of screws.

GEAR RATIO SELECTOR

To change the setting of the gear ratio selector,
proceed as follows:
To select the high speed setting (drilling and hammer
drilling), slide the selector switch to the rear position.
The number '2' appears. If necessary, when
changing the gear ratio, depress the trigger switch
sufficiently to rotate the chuck slowly.
Warning! Do not change gear when the chuck is
rotating at other than low speed.

TORQUE ADJUSTMENT COLLAR

To select non-masonry drilling, rotate the collar until
the drill symbol is in line with the indicator on the top
of your drill housing.
The torque adjustment collar has 23 positions and
provides adjustment of the torque necessary to seat
screws of a given size in a particular material.
Proceed as follows:
correctly seated, rotate the torque adjustment collar,
Your drill has a variable
as necessary, until the clutch slips when the head of
speed trigger switch.
the screw is flush with the surface of the material.
The more the trigger
Use this torque setting when fitting the remaining
switch is depressed, the
screws.
higher the speed of your

FAST CHARGER AND DETACHABLE BATTERY PACK

drill. If your drill has a
Your drill has a fast charger and detachable battery
gear ratio selector, the
pack. To increase the availability of your drill you can
purchase an additional battery pack.
Your drill is fitted with a long lasting pack from
Black & Decker which offers 25% more run time than
our standard range.

CHARGING YOUR CORDLESS DRILL

Important! The battery pack in your drill is not
charged when supplied as new. A new battery, or
one which has not been used for an extended period,
achieves full performance only after approximately
5 charging and discharging cycles. Before
attempting to charge your drill, read all the safety
instructions. To charge your drill, proceed as follows:
To select the low speed
Put the forward/reverse switch in the centre (lock-
setting (screwdriving
and high torque
applications), slide the
selector switch to the
front position. The
number '1' appears.
After normal usage your power pack should be fully
charged in 3 hours or less. If your power pack is run-
down completely it may take up to 8 hours to
become fully charged. Your power pack was sent
Set the torque
from the factory in an uncharged condition; before
adjustment collar to
attempting to use it, it must be charged for at least
position '1'.
6 hours.
Fit and tighten the first
To prolong your power packs' life, avoid leaving it on
screw. If the clutch of
charge for more than 8 hours. Although
your drill starts to slip overcharging is not a safety concern, it can reduce
before the screw is the overall life of your power pack.
ENGLISH
off) position. Remove
all accessories from the
chuck. To remove the
battery pack, depress
the two release buttons
and withdraw the
battery pack. Plug the
charger into a standard
220/240 V socket. Place
the battery pack in the
charger. While
charging, your battery
pack may hum and
become warm to the
touch; this is normal.
7