Operator Panel - Function Button(2)
The operation can be performed by carrying out the following
steps
To toggle the system status between "Maintenance" and "Normal"
•
Keep the Function Button pushed for three seconds
•
The MAINT/ID LED lights green when the system is in Maintenance mode
•
The MAINT/ID LED is off when the system is in Normal mode
Switch the functionality of Master CM to the other Controller Module
•
Push down the Function Button twice within three seconds
•
The Master LED lights green to indicate the Master CM
Reset the LAN ports of the CM to the default values
•
Push down the Function Button three times within three seconds
•
The MAINT/ID LED blinks green for a few seconds
Hardware Installation
ETERNUS DX80 S2 and DX90 S2
20
Copyright Fujitsu Technology Solutions, Release August 2011