ProForm PRO 2000 User Manual page 15

14. Raise the Frame (52) to the position shown.
Have a second person hold the Frame until
step 15 is completed.
Orient the Storage Latch (56) so that the decal is
facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (56) to
the bracket on the Upright (84) with a 5/16" x 1
3/4" Bolt (3) and a 5/16" Nut (9).
Raise the Storage Latch (56) to a vertical posi-
tion. Then, remove and discard the tie (F).
15. Align the upper end of the Storage Latch (56)
with the bracket on the Frame (52). Insert a
5/16" x 2 1/4" Bolt (4) through the bracket. This
should push a spacer (G) out of the other end.
Discard the spacer.
Attach the Storage Latch (56) with the 5/16" x 2
1/4" Bolt (4) and a 5/16" Nut (9).
Lower the Frame (52) (see HOW TO LOWER
THE TREADMILL FOR USE on page 26).
16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 28 and 29). Note: Extra parts may be
included.
14
F
Decal
15
9
G
15
52
56
9
84
3
52
4
56