Table of Contents
Advertisement
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well venti-
lated area when charging.
Safety of others
This appliance is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing the use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving
parts.
Injuries caused when changing any parts, blades or
accessories.
Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF.)
Electrical safety
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
a regular mains plug.
Symbols on the charger
Read all of this manual carefully before using the
appliance.
(Original instructions)
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
w
corresponds to the voltage on the rating plate.
Fail-safe isolating transformer. The mains supply is
x
electrically separated from the transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
$
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Charging indicator
4. Charging socket (WD4810 Only)
5. Dust bowl
6. Charger
7. Charging base (WD9610 Only)
Fig. A
10. Wet/Dry foam insert (WD4810 and WD9610 Only)
(WD4810 and WD9610 Only)
11.
Fig. B
12. Squeegee (WD4810 and WD9610 Only)
Assembly
These models may be supplied with some of the following
accessories:
A squeege tool (12) for wet use on hard surfaces.
(WD4810 and WD9610 Only)
Fitting (Fig. D)
Insert the appropriate accessory into the front of the appli-
ance. Make sure that the accessory is pushed fully in.
ENGLISH
5
Advertisement
Table of Contents
