How To Operate Your Dishwasher - GE GSD580 Use And Care Manual

How to operate your dishwasher

II
STEP 1. Load your dishwasher
with dishes, silverware, pots,
pans, bowls, etc. according to
instructions on pages 8 and 9.
STEP 2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
make sure the rinse agent container
is at least half full. (See page 6.)
STEP 3. Select HEATED DRY.
HEATED DRY. Turns the drying
heater on for fast drying.
ENERGY SAVER (no heat boost).
Turns the drying heater off to save
energy. Dishes will dry naturally
over a longer period such as
overnight.
If vou need vour dishes sooner.
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
NORMAL WASH cycle.
4
HEATED ENERGY
SAVER
STEP 4. Select the cycle and start
dishwasher. (See Cycle Selection
Hints on next page.)
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher.
For POTSCRUBBER and
NORMAL WASH cycles:
POT- NORMAL
SCRUBBER WASH
m
a. Push selected cycle button.
b. Latch the door.
LIGHT
RINSE &HOLD
Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
You will hear the motor start.
There is a time delay between
start-up and water fill so you
will not hear any wash action
right away.
To obtain the benefits of a complete
cycle, be careful that you do not
turn the dial any further than
necessary to start the dishwasher.
For LIGHT WASH cycle:
a. Be sure door is unlatched.
b. Push NORMAL WASH button.
c. Slowly turn Cycle Indicator Dial
to LIGHT WASH position.
d. Latch door to start the cycle.
For RINSE & HOLD cycle:
a. Be sure door is unlatched.
b. Select ENERGY SAVER drying
option
WASH
WASHING
DRYING
c. Slowly turn Cycle Indicator Dial
to RINSE & HOLD position.
d. Latch door to start the cycle.
I
I
HOLO
. LIGHT WASH
WASHING
o&F ;N
. LIGHT WASH
WASHING
RINSE &HOLO ,!,s1 '?i}:Jo"l