Black & Decker NV3610N Manual page 8

ENGLISH
x
The charger automatically shuts off if the ambi-
ent temperature becomes too high. As a con-
sequence the charger will be inoperable. The
charging base must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
$
The charging base is intended for indoor use
only.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6. Dry pick up cloth filter
7. Pre-filter
Installation
Wall Mounting (fig. B)
The product can be attached to a wall to provide a convenient storage and charging
point for the appliance.
When fixing to a wall, make sure that the fixing method is suitable for the wall type and
is appropriate to the weight of the appliance.
Mark the location of the screw holes (within reach of an electrical outlet for charging
u
the vac while it is on the wall bracket).
Fix the mounting bracket to the wall using appropriate screws and plugs for the type
u
of wall and weight of the appliance.
Hang the appliance on the wall by placing the opening on the base of the vac over
u
the hooks in the wall mount charging bracket.
Use
Before first use, the battery must be charged for at least 24 hours.
u
Place the appliance on the charging bracket whenever it is not in use.
u
Charging the battery (Fig. B)
Make sure that the appliance is switched off. The battery will not be charged with
u
the on/off switch in the on position.
Place the appliance on the charging bracket (5).
u
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge for at least 21 hours.
u
8
(Original instructions)