Warning! Never attempt to replace the charger unit
with a regular mains plug.
Use your BLACK+DECKER charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
Never attempt to charge nonrechargeable batteries.
If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised Black & Decker
Service Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well
ventilated area when charging.
Your charger has been designed for a specific
voltage. Always check that the mains voltage cor-
responds to the voltage on the rating plate. Never
attempt to replace the charger unit with a regular
Symbols on the charger
Read all of this manual carefully before using the
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
Short circuit proof safety isolating transformer.
The mains supply is electrically separated from
the transformer output.