Integral Audio SoundStage + Subwoofer System Installation Manual page 11

c.
11
25. run signal wiring tO aMp
Beginning in the left (driver's) side footwell, run the signal har-
ness along the door sill, and under the carpet in the rear seat foot-
well area, and to the area under the passenger seat. Be sure the
wiring is clear of all pinch points, including the Seat Belt screw.
26. aMplifier MOunting (Overview)
The amplifier mounts in the compartment under the passenger
seat. If your vehicle does not have a compartment with cover un-
der the seat, one has been included in your kit. You will cut the
carpet, remove the foam block inside, and then mount the amp.
27. triM carpet fOr cOMpartMent cOver
[FOR VEHICLES WITH CARPET UNDER SEAT]
Lay the Multifunction Box Cover on the area underseat. Note
where the carpet needs to be cut and mark with tape. Cut the
carpet and foam backing with a utility knife. Cut CAREFULLY -
there are wires running along the front edge of the compartment.
The carpet should be cut SMALLER than the cover or there will be
exposed area. If in doubt, remove the drivers seat and compare.
Notch the carpet in the mounting screw areas.
28. reMOve the plastic tuB
[FOR VEHICLES WITH EXISTING PLASTIC COVER]
Remove the plastic tub liner from the compartment. Detach any
equipment mounted to it.
DO NOT remove or remount the DSC module (see image)
29. attach aMplifier MOunting plate
Attach the amplifier to the mounting plate using the #6 x 3/8"
screws. Cut strips of the 3M Double-Sided Foam Mounting tape
and affix one side to the back of the amp mounting plate and any
original equipment from the underseat compartment. Arrange
all components so that they fit. Clean all components and the
sheet metal with an Alcohol Prep Pad prior to attaching the Foam
Mounting Tape.