Wiring Harness - MTD "A" Series Professional Shop Manual

Wiring harness

Key switch
Figure 6.12
Positive lead
Charger port
Figure 6.13
Engine connector
Figure 6.14
To remove/replace the harness:
1.
NOTE: The harness is a tight fit. It may be necessary to
2.
Harness
3.
4.
5.
6.
Negative lead
7.
Harness
8.
NOTE: Use new wire ties to secure the harness to the
9.
Disconnect the harness from the key switch.
remove the key switch to get enough leverage to
unplug it.
Cut off the wire ties that hold the harness to the han-
dle bars.
Remove the battery box cover.
Disconnect positive and negative battery leads.
See Figure 6.13.
Slide the charger port out of the battery box.
Lift the harness out of the battery box.
Disconnect the harness from the engine connector.
See Figure 6.14.
Install the harness by following the previous steps in
reverse order.
handle bars.
Test run the mower in a safe area before returning it
to service.
Electric start
33