MTD "A" Series Professional Shop Manual page 29

Hide thumbs Also See for "A" Series:

Table of Contents

Enlarged version

Axle assembly

Figure 5.6

Slide the longer end of the transmission output shaft

through the shaft support of the axle. When the

shorter end of the shaft clears the second shaft sup-

port, remove the transmission from the axle. See

Figure 5.6.

Install the transmission by following the previous

steps in reverse order.

NOTE: Apply a small amount of releasable thread locking

compound such as Loctite® 242 (blue) to the

wheel nut or replace it with a new one.

NOTE: Tighten the wheel nuts to a torque of 80 - 100 in lbs

(9 - 11 Nm)

Test run the mower before returning it to service.

Transmission

Table of Contents

Show Quick Links

Table of Contents

"b" series