Outdoor Unit Installation - Frigidaire FRS095YC1 Instruction Manual

Outdoor unit installation

1. Install the outdoor part of the unit
on a rigid surface to avoid excess
noise and vibration.
2. Direct the air vent toward an area
without obstacles.
3. Install the unit so that it is exposed
to as little wind as possible,
especially in areas where it is
frequently windy.
4. If the installation site is exposed to
heavy winds, such as in coastal
areas, place the unit along the
widest part of the wall or use
protective plates.
7. If need suspending installation, the
installation bracket should accord
with technique requirement in the
installation bracket diagram. The
installation wall should be solid
brick, concrete or the same
intensity construction, or actions to
reinforce, damping supporting
should be taken. The connection
between bracket and wall, bracket
and the air conditioner should be
firm, stable and reliable.
6. Be sure there is no obstacle which
block radiating air.
17
Stron wind
Settlement of outdoor unit
Anchor the outdoor unit tightly and
horizontally on a concrete or rigid
mount with a bolt and nut 10 or 8
diameter.
MODEL
700x535x235
685x430x260
780x540x250
760x590x285
820x600x345
845x695x335
895x860x330
Drain joint installation
Fit the seal into the drain elbow, then
insert the drain joint into the base pan
hole of outdoor unit, rotate 90 to
securely assemble them. Connecting
the drain joint with an extension drain
hose (Locally purchased), in case of
the water draining off the outdoor unit
during the heating mode.
+ =
Seal Drain joint Drain pipe
A
Air inlet
Air
inlet
B
Air outlet
A (mm) B (mm)
458 250
460 276
549 276
530 290
523 340
560 335
590 333
Base pan hole
of outdoor unit
Seal
18