Panasonic WJ-HD300 series Conversion Manualline page 3

WJ-HD300 S-ATA conversion guide
(2) Disconnect the connector from the front panel.
(3) Remove four screws that fix the HDD mounting unit, and
then pull the HDD unit toward you by holding the tabs of
the angle.
(4) Remove four screws fixing the upper HDD.
Disconnect the IDE connector and power connector from
the HDD, and remove the HDD from the HDD mounting
angle.
Caution++++++++++++++++++++++++++++++++++++
When removing the screws, hold the HDD by hand to prevent
it from falling and being impacted.
+++++++++++++++++++++++++++++++++++++++++++
Panasonic System Solutions
Front panel
connector
Hold these
tabs and pull
Screws
Pull-ring
Flat cable
Screws for the upper
hard disk drive
(4 screws: 2 screws each
on the both sides)
2
Maintenance guide
D
S S
D
S S
Jumper pin
Power supply
cable
Hard disk drive mounting angle
HD300_SATAConversionGuide_B