Download Table of Contents Print this page

Base Grille; Refrigerator Use; Normal Sounds; Using The Control - KitchenAid Architect Series II KURO24LSBX Use And Care Manual

Overlay model
Hide thumbs Also See for Architect Series II KURO24LSBX:

Advertisement

Table of Contents

Base Grille

Remove the Base Grille
1. Open the refrigerator door.
2. Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the refrigerator.
A
3. Remove the base grille.
Replace the Base Grille
1. Open the refrigerator door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.

REFRIGERATOR USE

Normal Sounds

Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the refrigerator.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your refrigerator.
You may hear water running into the drain pan when the
refrigerator is defrosting.
You may hear clicking sounds when the refrigerator starts or
stops running.
8
B
A
A. Tabs
B. Screws

Using the Control

For your convenience, your refrigerator control is preset at the
factory. When you first install your refrigerator, make sure that the
control is still preset to the mid-setting as shown.
Adjusting Controls
The mid-setting indicated in the previous section should be
correct for normal usage. The control is set correctly when
beverages are as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the refrigerator colder, adjust the control to the next
higher setting. To make the refrigerator less cold, adjust the
control to the next lower setting.

REFRIGERATOR FEATURES

Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when
removing them to avoid impact from dropping.

Split-level Shelf

Your refrigerator has an adjustable split-level shelf for maximum
storage capability.
To Remove and Replace Shelf:
1. Remove the shelf by lifting it up and out of the shelf brackets.
Remove the shelf.
2. Replace the shelf by inserting it into the shelf brackets.
NOTE: Be sure that the shelf is level.

Advertisement

Table of Contents
loading

Related Manuals for KitchenAid Architect Series II KURO24LSBX

Table of Contents