Quick-Start Demonstration - Bounty Hunter titanium Camo Owner's Manual

QUICK-START DEMONSTRATION

I. Supplies Needed
• a Nail • a Zinc Penny (dated after 1982)
II. Position the Detector
a. Place the detector on a table, with the searchcoil hanging over the edge.
Or better, have a friend hold the detector, with the searchcoil off the ground.
b. Keep the searchcoil away from walls, floors, and metal objects.
c. Remove watches, rings, and jewelry.
d. Turn off lights or appliances, whose electromagnetic
emissions may cause interference.
e. Pivot the searchcoil back.
III. Power Up
Press
IV. Wave each object over the searchcoil
a. Notice a different tone for each object:
No Tone:
Medium Tone:
High Tone:
b. Motion is required.
Objects must be in motion over the searchcoil to be detected in this mode.
V. Press
Then press
VI. Wave the nickel and zinc penny
a. Neither coin is detected.
VII. Press the
a. "5¢" reappears on the display
VIII. Wave the Nickel
a. The nickel is now again detected.
b. The nickel has been "notched in."
IX. Press
X. Pass the quarter over the searchcoil
a. Move the quarter closer to and farther away from the searchcoil. Notice
the change in pitch and volume.
XI. Press and hold
a. Hold the quarter motionless over the searchcoil.
b. Notice that motion is NOT required.
c. Move the quarter closer, then farther away from the coil. Notice the
changing depth reading.
.
Nail (in default setting iron is not detected)
Zinc Penny & Nickel
Quarter
once to enter the DISC. LEVEL program
four times.
to toggle down to NOTCH. Then press
to toggle down to ALL METAL
• a Nickel • a Quarter
three times
7