Advertisement
Removing Outlet
Wall Plates
Some decorative wall plates may need to be removed for the proper
mounting of PetChatz. Removing wall plates requires some attention to
basic safety precautions. However, with reasonable care a homeowner
can easily complete the process.
Step 1
TURN OFF THE POWER
Go to the breaker box of the home and turn off the breaker supplying power
to the outlet. While this may seem unnecessary, there is a distinct possibility
that you will come in contact with the outlet itself as you remove the wall plate,
and you can experience severe shock in those cases. Since breakers are often
sparsely labeled or incorrectly labeled, be sure to leave an appliance such as
a lamp or loud radio plugged into the outlet and turned on so that you know
when you have turned off the power.
Step 2
DETERMINE IF TOOLS ARE NEEDED
Remove the screws from the decorative plate: Wall plates come in a variety of
styles, the most common of which are the one or two screw styles*. Determine
if you need a Phillips or a flathead screwdriver, and remove the screws from the
wall plate.
* For other styles refer to the wall plate manufacturers instructions for removal.
Step 3
TURN POWER BACK ON
22
General Hints
i
Manual Treat Dispense
• To dispense a treat directly from the
PetChatz unit, simply press the "Manual
Treat Dispense" button located on the
front of the unit (as shown in Figure A).
• A treat will be immediately dispensed
from the PetChatz unit and appear from
the treat chute.
i
Cleaning Your
PetChatz Unit
• Weekly cleaning of the treat hopper
and treat chute is recommended.
• Use a soft cloth and warm water. Using
detergents or chemicals is not
recommended.
• Using a damp cloth, wipe all surfaces
of the treat hopper and internal surface
of the treat chute.
• You may need to use a damp cotton
swab to remove treat fines
from crevices.
For more information and troubleshooting
www.PetChatz.com.
guide, go to
support@petchatz.com
(855-444-6544)
Figure A
23
23
Advertisement
