Wii Ac Adapter - Nintendo Wii Operation Manual

S y s t e m S e t u p
Using the Sensor Bar Stand
Communication between the Wii Remote and the Sensor Bar may be improved in some situations by mounting the Sensor Bar on the Sensor Bar stand; for example, if the TV is
sitting on the floor.
1. Remove the protective film from the foam pads 2. For additional stability, you can add adhesive backed foam tape from the supplied sheet. These can be applied
on the bottom of the Sensor Bar stand. to both the top and bottom of the stand.
3. If you are using the extra foam tape, 4. Attach the Sensor Bar stand to the Sensor Bar, aligning the pegs
remove the protective film from the on the stand with the holes in the bottom of the Sensor Bar.
piece on the top of the Sensor Bar stand.
Be sure to:
• Align the centre of the Sensor Bar with the centre of the TV.
• Align the front of the Sensor Bar with the front edge of the TV, or with the front edge of the surface that the TV is sitting on.
16
If desired, the Sensor Bar cable can be fed through a channel on the bottom of the
Sensor Bar to orient the cable to the left or right.

Wii AC Adapter

1. Insert the DC plug on the Wii AC Adapter cord into the DC input connector on the
back of the console.
2. Insert the AC plug into a standard 230-240 volt household electrical outlet. Make
sure the power is off (the Power LED is red) when unplugging the AC Adapter.
CAUTION: Please also refer to the Health and Safety information on pages 2 and
3 of this manual.
5. Mount the Sensor Bar stand to:
To prevent electric shock or damage to Wii, do not try to use any other type of AC
• the front edge of the surface the TV is sitting on, or
adapter or power supply.
• to the top of the TV.
To prevent electric shock or cord damage, carefully disconnect any plugs from Wii or
Do not place the Sensor Bar stand below the
electrical outlet by pulling the plug, not the cord.
surface that the TV is sitting on; for example, on
shelves below the TV.
To avoid excessive wear to the AC Adapter connector, do not disconnect the AC Adapter
from Wii except when storing your Wii. For the purposes of power saving and safety,
disconnect the AC Adapter from the outlet after use of Wii.
Sensor Bar cable position
WARNING
CAUTION
NOTE:
<1> For the Wii system, use only an exclusive Wii AC Adapter: RVL-002(AUS), do not use any other type
of AC Adapter.
<2> The AC Adapter should be inspected regularly for damage to its cable, plug and body. If damage is
detected, the AC Adapter must not be used. A damaged AC Adapter must be returned to an
authorized repair agent for service.
<3> The AC Adapter is not a toy, but a power supply for Wii.
<4> If the external cord of the AC Adapter is damaged, it must be replaced by the
manufacturer or an authorized repair agent.
<5> The AC Adapter is for indoor use only.
<6> In the event of damage the AC Adapter must not be used until the damage has been repaired.
Wii is to be disconnected from the AC Adapter before cleaning.
230V-240V AC outlet
DC Input Connector
17