Install The Coolant Tank; Check The Coolant Pump - Foley United ACCU-Pro 670 Assembly And Service Manual

ASSEMBLY INSTRUCTIONS (Continued)

INSTALL THE COOLANT TANK

Assemble the Coolant Tank as outlined in the instructions
(Part No. 7467909) in the coolant tank carton.
Center the Tank under the Grinder.
Install the 1" I.D. drain tubing over the barbed end of the
plastic adapter on the coolant tray drain. Cut the tubing to
the proper length to reach about 1-1/2" [40 mm] into the
large opening on top of the Coolant Tank. See FIG. 12.
A pre-filter sock is shipped with the Tank. Install it onto the
tubing, using the plastic tie provided. Drop the other end of
the sock into the opening on top of the Tank.
Read the coolant mixing directions and the electrical
warnings in the Coolant Tank instructions.
THE COOLANT RATIO AS SPECIFIED MUST BE
USED. TO HIGH A CONCENTRATION OR LOW A
CONCENTRATION WILL CAUSE CORROSION
AND PERFORMANCE PROBLEMS.
1. Be sure the COOLANT PUMP switch is OFF. Mix (Part
No. 3708620) coolant in the coolant tank, at a ratio
of 50 parts water to 1 part concentrate. This will take
about 6 gallons of water and 1 pint of concentrate (24
liters of water and 0.5 liter of concentrate).
Refer also to the label on the coolant container, and the
instructions packed with the Coolant Tank.

CHECK THE COOLANT PUMP

Plug the pump motor cord (from the top of the Tank) to the
female connector from the control box.
RISK OF ELECTRICAL SHOCK!
MAKE CERTAIN THAT THE ABOVE
ELECTRICAL CONNECTION IS
SECURED ABOVE AND AWAY FROM
POSSIBLE CONTACT WITH THE
COOLANT.
Turn all control panel switches OFF. Close the guard door
and press START. Press Coolant Pump Switch to ON.
Check that the Coolant System functions properly. Be
prepared to press STOP if there is any problem.
NOTE: If the unit doesn't begin to pump coolant, press the
reset button on the motor contactor inside the control box.
See FIG. 13.
Secure any excess electrical cord to a crossbar on the
underside of the machine.
11
FIG. 12
FIG. 13