Foley United ACCU-Pro 670 Assembly And Service Manual page 19

ADJUSTMENTS (Continued)
TO REPLACE THE CARRIAGE LINEAR BEARINGS
7. Attach the three linear bearing pillow blocks loosely to
the bottom of the carriage, with their tension adjustment
screws (FIG. 23) facing outward.
8. Clean the carriage rails.
NOTE: The two rails are interchangeable and are also
reversible (end-for-end).
9. Insert a rail through the rear two pillow blocks, and align
the rear pillow blocks to each other with a straight edge
laid along their sides. See FIG. 25. When aligned, tighten
the four socket-head screws which hold each rear pillow
block. Slide the other carriage shaft through the front
bearing, but do not tighten the socket head screws.
10. Lift the complete carriage assembly back onto the
Grinder main base, and secure the rear carriage rail
to its V-groove bosses with the six bolts.
11. With the front rail resting in the V-groove bosses and the
carriage approximately centered on the machine, tighten
the two outside socket-head screws which secure the front
pillow block. Lift the front of the carriage, and tighten the
two inside pillow-block screws. Secure the front carriage
rail to its V-groove bosses with the six bolts.
12. Recheck the bearing tension. The tension is correct
when you try to lift the carriage and can feel no free
carriage movement up or down.
Check for excessive carriage-traverse load by using a
spring scale to pull on the carriage parallel to the drive
shaft (as in FIG. 19). There should be only about a 3- to
5- lb. pulling force.
To double-check, manually slide the carriage assembly
from one end of its travel to the other. There should
be uniform resistance through the full range of travel.
13. Slide the linear actuator under the carriage, and line up
the hole in the carriage with the tapped hole in the top of
the actuator block. Insert the actuator mounting screw
through the self-aligning bearing, and tighten it.
Be careful not to cross-thread the screw.
14. Reinstall the feed screw guide mounting screws and then
the actuator release lever into the linear actuator.
15. If being used, reattach the two carriage bellows. Refer
to the assembly section of this manual.
Straightedge
19
Rear Pillow Blocks
Underside of
Carriage
FIG. 25