Check The Carriage Traverse; Check The Grinding Motor; Charging To Supplementary Power Supply - Foley United ACCU-Pro 670 Assembly And Service Manual

ASSEMBLY INSTRUCTIONS (Continued)

CHECK THE CARRIAGE TRAVERSE

Move the proximity switch assemblies to about 12" [300 mm]
from the ends of the machine, and tighten their knobs.
Visually check that the grinding head will be able to traverse
to both sides of the machine without contacting any
components.
Turn all control panel switches OFF. Set the TRAVERSE FT/
MIN knob to zero. Close the guard door and press START.
Press CARRIAGE TRAVERSE to ON. Set TRAVERSE FT/
MIN to a low speed, and check that the grinding head runs
through a complete traverse cycle. Be prepared to press
STOP if there is any interference. Watch carefully for
obstructions to the head travel, and check that the grinding
motor cord and proximity switch cords are not stretched.
NOTE: If the unit doesn't begin a traverse cycle, press the
reset button on the motor contactor inside the control box.
See FIG. 13.

CHECK THE GRINDING MOTOR

Turn all control panel switches OFF. Close the guard door to
connect the interlock. Press START. Press Grinding Motor
Switch to ON. Check that the grinding head runs properly.
Be prepared to press STOP if there is any problem.
NOTE: If the grinding head doesn't begin properly, press the
reset button on the motor contactor inside the control box.
See FIG. 13.

CHARGING TO SUPPLEMENTARY POWER SUPPLY

The Supplementary Power Supply (SPS) comes from the
supplier with no charge. When the machine is ready for
operation, plug it in and turn on the SPS. The battery will
charge in six hours. For SPS functions, refer to the separate
manual supplied with the grinder.
MAKE FINAL PREPARATIONS FOR OPERATION
Carefully read the operating instructions in the Operators
Manual.
First, study the pages titled "Getting to Know Your Grinder"
and "General Operating Information" for important
background explanations about the machine and about
bedknife grinding. Then, read the "Operating Instructions"
pages for step-by-step procedures on mounting the
bedknife and grinding its top and front faces.
12