Table of Contents
Advertisement
This machine is intended for grinding the bedknife from a reel mowing
unit ONLY. Any use other than this may cause personal injury and void
the warranty.
This machine is intended for indoor use only.
To assure the quality and safety of your machine and to maintain the
warranty, you MUST use original equipment manufactures replacement
parts and have any repair work done by a qualified professional.
ALL operators of this equipment must be thoroughly trained BEFORE
operating the equipment.
Do not use compressed air to clean grinding dust from the machine. This
dust can cause personal injury as well as damage to the grinder. Do not use a
power washer to clean the machine.
Assembly...................................................................................................... Page 6 - 12
Maintenance ................................................................................................ Page 13 - 15
Adjustments ................................................................................................. Page 16-23
Troubleshooting ........................................................................................... Page 24-33
Electrical Schematic ..................................................................................... Page 34
Parts List. ..................................................................................................... Page 35-48
Electrical Requirements ............................................................ 115V 50/60 Hz, 15-amp circuit
Net Weight ....................................................................................................... 780 lbs [354 kg]
Shipping Weight ............................................................................................... 920 lbs [417 kg]
Maximum Grinding Length ................................................................................ 34 in. [863 mm]
Sound Level..................................................................................................... Less than 75 Dba
Low Voltage Relay
The grinder is equipped with a low voltage relay which
is factory preset at 100 VAC. If the power supply line
does not deliver 100 VAC power under load, the relay
will open and trip out the starter. If this occurs, your
power supply line is inadequate and must be correct
before proceeding further with the grinder.
ADJUSTMENT OF THE LOW VOLTAGE RE-
LAY MAY CAUSE ELECTRICAL COMPONENT
FAILURE. ADJUSTMENT OF THE LOW
VOLTAGE RELAY WILL VOID ALL
ELECTRICAL COMPONENT WARRANTY.
CONTENTS
SPECIFICATIONS
4
Hide quick links:
Advertisement
Table of Contents
