Table of Contents
Advertisement
•
Select correct heat position.
•
Set the timer to the correct position (See programme around the
timer on fascia panel).
•
For energy labeling purposes (EN61121:2005) for a cotton dry load,
use the maximum load weight for cotton and set the timer to the
recommended drying time for cotton dry as specified on the control
panel.
•
The standard cotton programme used at full and partial load is the
standard drying programme to which the information in the label
and the fiche relate. This programme is suitable for drying normal
wet cotton laundry. It is the most efficient programme in terms of
energy consumption for cotton
•
Your appliance is a reversing, small door opening, dryer. A full load
will typically take 130 minutes and will use approximately 4.48kWh
of electricity. A half load will typically take 75 minutes and will use
approximately 2.32kWh of electricity.
•
Press the start button.
•
The drum will now begin to rotate and will stop automatically when
the timer reaches the "0" position.
•
Once the clothes are removed, clean the filter.
•
Switch off the electricity supply.
Should the clothes become dry before the cycle has finished the
thermostat will automatically switch off the heater to prevent over
drying and save energy although the drum will still rotate.
When drying large items, such as sheets, we suggest you stop the
dryer periodically to redistribute the load.
7
Advertisement
Table of Contents
