Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ASL INTERCOM PS 6379 Mk2
Summary of Contents for ASL INTERCOM PS 6379 Mk2
-
Page 1: User Manual
PS 6379 Mk2 SIX CHANNEL MASTER SPEAKER STATION USER MANUAL October 2013 This product is designed and manufactured by: ASL Intercom B.V. Zonnebaan 42, 3542 EG Utrecht The Netherlands Tel: +31 (0)30 2411901 Fax: +31 (0)30 2667373 Email: info@asl-inter.com Web:... -
Page 2: Table Of Contents
FRONT PANEL CONTROLS & CONNECTOR ........6 REAR PANEL CONNECTORS & SWITCHES ........11 10.0 IFB FUNCTION ................... 14 11.0 DIP SWITCHES .................. 14 12.0 TECHNICAL SPECIFICATIONS ............15 PAGE 2 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... -
Page 3: Safety Instructions
Operate the apparatus using only the type of power source indicated on the marking label. Unplug the apparatus’ power cord by gripping the power plug, not the cord. PAGE 3 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... -
Page 4: General Description
In case AC mains is not available, the unit may be powered by an external DC power source (24 – 30V) which can provide 105 watts. PAGE 4 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... -
Page 5: Unpacking
This wire is in the PS 6379 Mk2 connected to all exposed metal surfaces. Any rack framework into •... -
Page 6: Front Panel Controls & Connector
If a TALK button is pushed shortly, it is electronically latched and the microphone signal is sent to the referring intercom channel. If pushed again, the TALK button switches off. PAGE 6 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... - Page 7 BUZZER MUTE button is switched off again (the Buzzer Mute status is abolished). The BUZZER MUTE button of a channel in IFB mode is automatically disabled. PAGE 7 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV...
- Page 8 2 seconds the buzzer is activated, should no buzzer mute be activated for that channel. After the CALL TO TALK button is released the LEDs continue to flash for a further 2 seconds. PAGE 8 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV...
- Page 9 (the ones which has to be changed. See section 11.0 DIP switch were lit before the ALL BUZZER MUTE button was pushed remain being lit) PAGE 9 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV...
- Page 10 IFB mode. If the knob is fully clockwise, the into the headset microphone.The gain for the DIM factor is at its maximum (100% dimming) headset mic can be adjusted by trimmer #45. PAGE 10 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV...
-
Page 11: Rear Panel Connectors & Switches
ASL party line 2 or AUX 3 to the corresponding channel Intercom system which has its own power supply. For more information, see #10 PAGE 11 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... - Page 12 STAGE ANNOUNCE RELAY This Phoenix type connector gives access to a normally open contact, which is closed when the Stage Announce button is pushed. INTERNAL CONTROLS PAGE 12 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV...
- Page 13 Master Volume knob (see #6) determine - for each channel separately - the and – in case of binaural use of the PS 6379 Mk2 routing of the audio to the headset cans: either to – the routing of the PGM signal to the headset the left can, or to the right can, or to both cans or cans.
-
Page 14: Ifb Function
IFB mode. 11.0 DIP SWITCHES Inside the PS 6379 Mk2 the following DIP switches are to be found: PAGE 14 User Manual PS 6379 Mk2 / October 2013 © ASL Intercom BV... -
Page 15: Technical Specifications
DIP switch D STAGE ANNOUNCE and SPEAKER ON/OFF If this DIP switch is in ‘OFF’ position (= factory setting) the speaker of the PS 6379 Mk2 is automatically switched off for as long the STAGE ANNOUNCE button is being pushed. In the ‘ON’ position, the speaker is not switched off for as long as the STAGE ANNOUNCE button is being pushed.
Need help?
Do you have a question about the PS 6379 Mk2 and is the answer not in the manual?
Questions and answers