Table of Contents
Advertisement
A compressor service valve should be located at the hose reel inlet or the customer's air connection
port when a hose reel is not used. Typical plumbing from the machine's air outlet port occurs in the
following order:
1. Air tank
2. OSHA valve.
3. Service valve.
4. Moisture trap/gauge/oiler combination (when used).
5. Hose reel (when used).
5. Pre-Start-up Inspection Checks
This inspection should be done prior the compressor test.
I.
Check all assemblies, clamps, fittings, hose connections, nuts, and bolts to ensure they are properly
tied and secured to the vehicle. This is a very critical area of inspection. The vehicle should not be
moved until this inspection has been completed.
II.
Remove all tools, rags, and installation equipment from the area.
III.
Check compressor oil level and hydraulic fluid level. Check all valves to ensure they are in correct
operating position.
IV.
Apply decals to proper location. Make sure that the area is cleaned prior to applying decals. All
decals should have a professional appearance upon application.
V.
Vacuum all areas that have metal or plastic shavings. Wipe all fingerprints off unit and vehicle.
Installation & Operation
14
308528
Advertisement
Table of Contents
