Table of Contents
Advertisement
Navigation Interface Operation:
CUE Equipped Vehicles:
To change the OEM radio to Navigation Mode:
•
Press on an open area on the screen for 3 seconds.
•
Press the Nav switch if installed.
•
Press the SWC Nav switch for 3 or more seconds if installed.
Exit Navigation by:
•
Pressing again on an open area of the screen for 3 seconds.
•
Press the Nav switch.
•
Press the SWC Nav switch for 3 or more seconds if installed.
For Navigation operation see the included quick start guide or download a full user's manual from
I
f the picture is not centered or does not fill the screen correctly you can adjust the picture size. Access the settings menu by
pressing the Menu button on the side of the Nav Interface Module.
Use the Menu button to scroll through the options and "+" or "-" buttons to adjust the value.
1. Contrast, Brightness and Saturation are all screen adjustments for picture quality.
2. Position H and V are for Horizontal and Vertical Position, use to adjust to fit factory screen as needed.
3. IR-AV1, IR-AV2: NOT USED. Select NONE to insure proper operation.
4. Guide-L, Guide-R-CNTRL -These are controls for the position of the Parking Lines. By selecting + or - you can move the
position of the lines to match the vehicle width.
5. H-Size, V-Size: This will adjust the picture to meet the full screen size of the OEM panel.
WWW.ADVENTPRODUCTS.COM
Setup Menu
Contrast----------------------------50
Brightness-------------------------50
Saturation-------------------------62
Position-H-------------------------23
Position-V-------------------------3
IR-AV1------------------------------NOT USED
R-AV1-------------------------------NOT USED
Guide-L-----------------------------0
Guide-R----------------------------3
Guide-CNTRL---------------------OFF
H - SIZE-----------------------------16
V - SIZE-----------------------------40
4
.
Advertisement
Table of Contents
