Memory Reset; Accessory Connection Gable; Installing The Kct-19 In The Transceiver - Kenwood TK-768 Service Manual

TK:768/H
REALIGNMENT/
T,H'TNÊ/ INSTALLATION
I g#,
t
:i
, i
:
ffi
s
7. Memory Reset
This function initializes the data in the EEPROM of
the transceiver.
7-1. OPeration
1. Hold down the [A] key and turn the power on, and
keep the tAI key pressed for two seconds to enter
the initial mode' The display changes form "PrOG"
t o " S E L " .
2. Press the IVOLVI and [D/Al keys at the same time
to reset the memory. ffhe display does not change')
The model name, F version and tuning data is not
initialized.
INSTALLATION
1. Accessory Connestion Gable
( KCT-19 : OPtionl
The KCT-19 is an accessory connection cable for
connecting external equipment. The connector has 15
pins and the necessary signal lines are selected for
use.
1-1. Installing the KCT-19 in the transceiver
1. Remove the upper and lower halves of the trans-
ceiver case' and lift the DC cord bushing (o) from
the chassis.
2. Remove the pad (e).
t#
f .isÊÈrËEil'í+
( rcr-r e : iË[6 )
Kcr- le Ë - & E ïË&tl.*FiAá Ét ËÊÊ.rrË. ÍL É
ffi Rá ts RÊffi 4 U iË H tf ffi $J lÈ Ê tÈ'.
1 -1 . EiE'íËtJtÊ Ê# Kcr-1 s
i. ry.TlÉ'íàflÉ0iTtrtÊ' fÁflÈiËËËffiÈW+
*,ffiq*EÊ (o) "
2. HT4.H (o) .
7. ïFfËËË€{È
xf iÉíàil Ét EEPROM
E tÈ#fïE Mfr #.ryJffi 4t' "
7.1.RTÊfrW
1. &,ít IAJ 6Ë, ïTrÈwfi* ,M&&lt IAJ 6Ê' ',íx
#!\ z tlffi, [{it^ïxlÊ'Ëtt"
)t^UJffi+WHtt, .'EzÍFtftfrgA rPrOG: +re, *
ES4' rSELr ?ffi.
2. &4È (VOLV) fi*'& (D,/A) 6Ë, I|lXfFffi**E&
ffi 4 4' tt fr ffi U e Ë ifr ffi ffi T fr:fr UJffi +l' "
s
{
0
C
(
F i g . l
26