Annual Start-Up - Service; Annual Start-Up Procedure - Weil-McLain Gold GV Manual

• Installation • Start-Up • Parts • Maintenance
Annual start-up —
service
Annual start-up —
start-up
Part number 550-141-856/0703
Blower motor (Figure 27)
1. With boiler power , place a few drops of S.A.E.
OFF
20 motor oil in each of the two oil cups.
Use only
lubricate the blower motor. Do not
use universal household oils. Motor
could be damaged, resulting in
possible severe property damage.
Oiled-bearing circulators
1. Both of the circulators installed in the boiler are
water-lubricated. No oiling is required.
2. Check other circulators in the system. Oil any
circulators requiring oil, following circulator
manufacturer's instructions. Over-oiling will
damage the circulator.
Start-up procedure
1. Follow the instructions in manual Section
2. Verify
cold fill pressure
system is working properly.
3. Verify
antifreeze level
concentration and that inhibitor level is correct.
4. , per manual Sections
Check gas piping
verifying no indications of leakage and all piping and
connections are in good condition.
5. Read the
Lighting instructions
manual or on boiler label).
6. Start the boiler following the
and manual Section .
VIId
to
S.A.E. 20 motor oil
.
VII
is correct and that fill
(if used) is at the right
and ,
V VIIb
(Figure 25 of this
Lighting instructions
Figure 27 Blower motor
59