Hotpoint Ariston LFF 825 IT Service Manual page 21

4. Insert a small screwdriver or the tip of a tester into the hole next to the support to lift the hook securing
the support, then slide it in the direction indicated by the arrow.
Note.: be mindful of the wiring during dismantling and reassembly.
Fill Hose and Drain Hose:
1. Remove the four screws (two front, two rear) which secure the right side panel and remove the panel.
2. Turn the appliance upside down.
3. Remove the pan by releasing the tabs securing it to the lower support and sliding it out towards the
front of the dishwasher.
4. Insert a flat blade screwdriver to release the tab securing the hose support.
5. Lift up the cover and remove it.
6. Pull the drain hose to remove it from its seat (it is pressure-inserted).
7. Remove the clamp that secures the feed hose to the Air break and remove the hose.
Air break & Softener:
1. Remove the four screws (two front, two rear) which secure the right side panel and remove the panel.
2. Remove the ring nut that secures the Air break to the dishwasher tank.
3. Disconnect the Litre Counter Turbine connector.
4. Remove the Air break.
5. Remove the clamp that secures the feed hose to the Air break.
6. Remove the plug and ring nut of the softener.
7. Disconnect the regeneration valve and release the softener from its support hook.
8. Rotate the softener, lifting it up to remove it laterally.
Note.: be careful with the Air break feed hose, pushing it in towards the base in order to prevent the
softener disengaging.
10. Disconnect the salt reading module.
11. Remove the softener-reservoir hose clamp.
12. Remove the softener.
Reservoir:
1. Remove the filters and the lower rotor.
2. Remove the two fixing screws of the top rotor delivery hose to release it from its coupling.
3. Remove the four screws of the reservoir ring nut and remove it.
4. Turn the machine upside down and remove the pan.
5. Carry out the disassembly of the AC wash motor.
6. Carry out the disassembly procedure of the electric wash pump.
7. Remove the drain hose and unscrew the drain pump.
8. Disconnect the conductivity sensor.
9. Disconnect the NTC.
10. Remove the reservoir
Top rotor delivery:
1. Remove the racks.
2. Remove the filters and the bottom rotor.
3. Remove the two fixing screws of the top rotor delivery hose to release it from its coupling.
4. Use a flat blade screwdriver for leverage at the side in order to release the upper rotor delivery hose
from its seat.
Service Manual
Manual LFF 825 IT/HA
Edition
2008.04.01
21
Language
English