SAFETY PRECAUTIONS ● Keep this appliances out of reach from children. Do not let them to operate the appliance without supervision. ● To protect against the risk of electrical shock, do not immerse the product, cord or plug into water or any other liquids. ●...
Instructions for Installation Make sure to have the authorized dealers or our service centre to carry out installation of the appliance. 1. The units are not to be installed at places where Make sure that the earth leakage-circuit breaker there might be leakage of combustible gases. is installed.
Page 4
Try to avoid the sunlight and hot air Try to minimize the generation of heat Do not use combusting apparatuses from entering the room. during the operation of cooling. in the air-conditioned room. I'm scorched! During the cooling operation, curtains or window- It might lead to the incomplete combustion of these blinds should be used to shade off the sunlight.
Product Descriptions Indoor Unit Operational performance/indications Air return grid Takes in the indoor air Lelf/right air flow direction adjusting fin Up/down air flow direction adjusting flap Air outlet Air blows out from here Air filter Removes dust or dirt out of the inlet air Drain tube Drain the water dehumidified out of the air conditioner Outdoor Unit...
Page 6
Unit operation section How to open Lightly push both sides of the air inlet grid at the bottom and pull it towards yourself until a resistance is felt. How to close Emergency operation key Push down the air inlet grid and then push both sides of air inlet grid at the bottom. The emergency operation key can be used as an emergency measure to turn on/off the unit when remote controller is not available.
Operation and Indication Sections of Remote Controller Attention: 1.Please check and refer the instruction for the remote controller. FAN SPEED indicator Temperature indicator Indicates the air delivery speed. Indicates the set temperature. OPERATION MODE indicator SLEEP indicator Indicates selected operation mode Indicates during sleep operation.
OPERATING INSTRUCTIONS Remote Controller 1. Point the remote controller at the unit,press the ON/OFF button,then press the MODE button,select the required mode: AUTO, COOL, DRY or FAN. 2. Press the SET TEMPERATURE button to increase or decrease the readings until the required temperature is displayed.The room set temperature range is from 16˚C-32˚C(61 ˚F-90˚F (It would be automatically set at 25˚C(76...
TURBO OPERATION Press TURBO button during COOL operation, the air rate can be set in HIGH. Press the TURBO button again to turn off the TURBO operation. Note: During TURBO operation, the air rate cannot be changed. ADJUSTING LEFT/RIGHT AIR FLOW DIRECTION Methods 1: Manually adjust Adjust the direction by moving the left/right air flow direction adjusting fin by hand.
NOTE: Use the sleep mode when you are going to bed.If this mode is used in the day,the capacity is reduced since the ambient temperature is too high.(COOL MODE). During the operation of cooling,the room temperature will be raised gradually by 2 C( 4 F) higher than the setting after the air conditioner begins to operate in the sleeping mode.
Page 11
The air conditioner must be turned off and unplugged before the maintenance is to be carried out. Before the season of operation During the season of operation The cleaning of the air filter screen (Standard intervals should be once every two weeks). Check if there are any blocking materials Remove the air filter screen from the unit.
Treatment at service call Please check the following before requesting after-sale service from your dealer . The air conditioner does not operate at all . Is the power plug into Is there a power Is the timer set to an outlet ? failure or a blown "ON"...
TROUBLESHOOTING Restart is stopped for 3 minutes after shut down to protect The unit can not be restarted just after shut down. the unit . (Power On lamp is illuminating) Please wait for Not operate 3 minutes . Three-minute protection timer incorporated in the microcomputer actuates automatically .
Need help?
Do you have a question about the EACI-D1051I(WH) and is the answer not in the manual?
Questions and answers