Switching On; Testing The Camera Coverage Area - Ranger BN058 Instructions For Use Manual

7.2 S
WItchIng
When you turn on the camera it automatically enters
Sleep Mode and will start taking photographs or video
after the delay time (see 6.2.4 Setting Delay).
7.3 t
eStIng the
After mounting the camera enter Setup Mode: open
the front housing and slide the power switch to ON,
press the OK button to enter General Mode and then
close the front housing.
A red indicator light on the front (the Working
Indicator) will blink as you intrude the PIR coverage
area.
Adjust the camera position and PIR sensitivity as
needed and repeat testing until you're happy with the
PIR coverage area.
▲ Press the SETUP button again when you've
finished testing the PIR coverage area to enter
Sleep Mode. The camera will now be ready to
take photographs.
o
n
c c
aMera overage
- 23 -
a
rea