freightliner Columbia Driver Manual page 24

Instruments and Controls Identification
Engine Information
The engine information screens allow you to view
engine mileage and hours, and total fuel consump-
tion. See Fig. 2.12. Tap the arrow keys on the 10-
key keypad to advance through the screens. Press
and hold the SET/RESET key to reset any of the
screens.
Diagnostic Information
If active fault codes are displayed on the diagnostic
information screens–See
the fault code and text message, then take the ve-
hicle to an authorized Freightliner service facility as
soon as possible.
Service Information
Service information allows you to view the next re-
curring service interval, expressed in either miles or
hours. See Fig. 2.14. Service intervals can also be
deactivated, so they do not display at all.
For programming service intervals, see Setup Infor-
mation, below.
NOTE: If the vehicle has gone past the service
interval, the miles (km)/hours remaining
screen is replaced by the service was due
screen, followed by the number of miles(km)/
hours since the service was due.
Return to
Idle Hours
Screen
INFORMATION AMT
Go to Diagnostic Information Screens
12/01/2004
2.15
Fig. 2.13, make a note of
From Fuel
Information
ENGINE ENG MILES 123456.7
ENG HOUR1234:78AMT
Fig. 2.12, ICU4M Engine Information Screens
Setup Information
See Fig. 2.15 and Fig. 2.16
setup information screens.
Setup information allows you to program various fea-
tures of the ICU4M environment, including:
A. Service intervals (OFF/MILES/HOURS);
B. Target MPG;
C.
LCD Lamp (ON/OFF);
D. Driver message center brightness;
E. Language (English/French/Spanish);
F. Units of measurement (English/Metric);
G.
Driver select (ON/OFF)
H. Reset parameters to original settings.
Vehicle Information Screens
The vehicle information screens display hardware
and software information, including the Freightliner
part number and switch ID of the ICU. See
ENG GALLONS 123456.7
PTO GAL 12345.6 AMT
If Oil Level Low
If Oil Level OK
If Oil Level High
for diagrams of the
Fig. 2.17.
ENG OIL LEVEL
LO −1 QTS AMT
ENG OIL LEVEL
LO −1 QTS AMT
ENG OIL LEVEL
OK AMT
ENG OIL LEVEL
HI 1 QTS AMT
f040701