Advertisement
Ion
Gateway
®
Cellular Gateway and Wireless Sensors
C
G
ellular
ateway
1. Understanding the Ethernet Gateway Lights
a.
Cellular
Network
Signal
a.
Cellular network registration is in
progress
Cellular registration is OK (Ion
Gateway is registered successfully
in the cellular network)
b.
Last communication transaction
with Ion
®
unsuccessful
Last Ion
®
with the server is OK
Blinking: Ion
communication with the server is in
progress
c.
Ion
Gateway Sensors
®
communication problem
Ion
Gateway communication with
®
the sensors is OK
Blinking: Sensors communication
with Ion
®
Note 1: The Ion
Gateway resets itself after receiving
®
new configuration from the server (ex. new HB), LED1
starts with RED and the reset cycle continues till all 3
LEDS are GREEN.
www.iongateway.net
b.
c.
Sensor
Signal
®
Gateway's server was
Gateway communication
Gateway
®
Gateway is in progress
QUICK START GUIDE
Dated: 02/03/2014
Document Name: Ion Gateway_QS
Note 2: After successful software upgrade, LED 2
and 3 flash RED then reset cycle starts.
2. Cellular Gateway Controls
a
a. Small antenna connector
b. Power switch
c. Power plug connector
d. Large antenna connector
e. Control button
3. Using the Control Button
a. Pressing the power button will turn the
device on or off. Powering on the device
will trigger the gateway to immediately
send all stored sensor messages to
the online system and download any
pending system messages to deliver to
the sensors. (The default heartbeat for the
cellular gateway is 60 minutes.)
b. Press and hold to Factory Reset Button
to reset the gateway to factory settings.
This resets the gateway heartbeat to 60
minutes. You will need to login to the
online system after resetting the gateway
to reconfigure the gateway to your desired
settings.
Page 4 of 9
c
d
b
e
Advertisement
