Rasmussen F Installation Instructions Manual page 5

STEP TWO: Burner Pan Assembly (continued).
With Accessory Safety Pilot Lighting Kits:
• RPK1-F, RPK1-F10-F or RMC1-F
(For use with Natural Gas Models F, FH, FX, FXH)
• RPK1-FA, RPK1-F10-FA or RMC1-FA
(For use with Propane/LP Gas Models FA, FAH, FAX, FAXH).
1. Assemble in accordance with specific instruction sheets provided with SAFETY PILOT LIGHTING KIT.
With Factory Installed Safety Pilot Lighting Kit SPK3
• SPK3-F (For use with Natural Gas Models FH-S3, FXH-S3)
• SPK3-FA (For use with Propane/LP Gas Models FAH-S3, FAXH-S3).
1. Verify factory assembly in accordance with diagram at FIGURE 6.
STEP THREE: Gas Supply Connection.
TYPICAL
INSTALLATION
STEP FOUR: Filling Pan with Medium (White Sand-used with
Natural Gas or Black Volcanic Ash-used with Propane/LP
Gas) and Placing EMBER MAGIC.
1. Completely cover BURNER TUBE and EMBER
BOOSTERS with the appropriate P A N M E D I U M . The
W H I T E S A N D i s f o r u s e w i t h N a t u r a l G a s , the
BLACK VOLCANIC
P r o p a n e / L P G a s . Use the ENTIRE CONTENTS of
the bag provided with the burner. Allow medium to spill over
leading edge of PAN.
2. Sprinkle a light covering of "EMBER MAGIC" over
the PAN MEDIUM. Pull apart "EMBER MAGIC" fiber
material to enhance the glowing emebr effect. Spread the
remaining "EMBER MAGIC" around ends of pan to
enhance ember bed appearance.
3. VOLCANIC ASH may be sprinkled around the
OUTSIDE of the BURNER PAN as a decorative effect.
C
B A
D
FIGURE 7
WARNING: DO NOT FLAME TEST FOR LEAKS.
ASH is for use
FIREPLACE GAS
SUPPLY VALVE
with
BURNER
TUBE
5
ENSURE THAT GAS SUPPLY TO
FIREPLACE IS TURNED OFF
1. Apply pipe compound to threaded end of GAS
S U P P L Y P I P E ( A ) . Thread 1 / 2 " F I P x 3/8"
FLARE ELBOW (B) onto G A S S U P P L Y P I P E
(A) and wrench tighten.
2. With BURNER PAN inside firebox at previously
marked position, thread (without pipe compound)
one end of the ALUMINUM CONNECTOR
TUBE (C) to the 1/2" FIP x 3/8" FLARE
ELBOW (B) and wrench tighten.
3. Carefully bending ALUMINUM CONNECTOR
TUBE (C), align and connect, without pipe
compound, to the FLARED BURNER INPUT
FITTING (D). Wrench tighten.
NOTE: ALUMINUM CONNECTOR TUBE (C)
may kink or break, causing air flow noise and/or
leaks if bent into too small a radius.
4. Turn gas supply to fireplace on.
5. Test all connections for leaks with soapy water
solution. If solution bubbles, turn off gas supply, re-
tighten fitting and recheck.
EMBER MAGIC
EMBER
BOOSTERS
PAN MEDIUM
FIGURE 8