Table of Contents
Advertisement
Step 5 – Test the PSU-PC19 before connecting the Xenarc SC8
It is recommended that you test the output of the PSU-PC19 before proceeding to the next
steps. Turn on the ignition and measure the voltage on the power connector pins 1 & 2 as
shown in the diagram below. The voltage should read approximately +19.4 volts.
Step 6 – Connect the CNX-CA-XSC8 power cable to the Xenarc SC8
Insert both the power connector and the ACPI connector into the SC8 as shown in the
diagram below.
CarNetix PSU-PC19 V2.0 Installation Manual
Pin
Wire Color
1
RED
2
WHITE
3
BLACK
4
YELLOW
Figure 5 Xenarc SC8/PSU-PC19 connections
- 17 -
Function
+19V
+19V
GND
GND
Advertisement
Table of Contents
