Hyundai HYW2400P Operator's Manual page 24

Unit does not
reach required
pressure
Thermal Relief
Valve is open
and discharging
water from side
of pump
Leak in the
fittings
Pump oil is low?
Oil is milky color
24
1. Restricted or insufficient
water supply.
2. Unsuitable or worn out
nozzle.
3. Regulator set too low.
1. Water temperature is too
high
2. Pump has operated
more than 3 mins without
pulling trigger.
1. Water leak in high
pressure fittings, hose or
gun.
1. Normal use consumes oil
over time
1. Seals have worn from use
and water has leaked in
Hyundai HYW2400P Pressure Washer
1. Check supply hose, faucet
and inlet water filter. Must
be connected to water
source which provides
6GPM
2. Replace nozzle
3. Reset unloader by
turning knob (clockwise
increases pressure)
1. Use cool water only.
2. Pull trigger at least 30
seconds every 3 mins
1. Use teflon tape or pipe
sealant to tighten hose
fitting, replace hose or
gun
**If problem continues, take to
your pressure washer dealer
1. To gauge the oil level,
look directly into the sight
glass. Oil level should al-
ways be at the centre dot.
Do not overfill. Replace
w/30W non detergent
mineral oil.
1. Bring unit to local service
center to have seals
replaced.
www.hyundaipowerequipment.co.uk
Operator's Manual