Setup Procedure
Signal Connections
1. Connect 6.3 mm mic jack from Unbalanced AF Output to amplifier s MIC IN
and set "impedance" at "LOW". Or connect 6.3 mm mic jack from "unbalanced
AF Output" to amplifier's "LINE IN" and set "impedance" at "HI". (The same
way can be applied in EJ-701DR
Remark: AF Impedance Selection only controls
Unbalanced AF Output (6.3 mm jack).
2. If using XLR mic jack connect it from
"Balanced AF Output" to amplifier's "AUX IN".
AF Impedance Selection (HI / LOW Control)
In order to prevent from the impedance from being too high thus producing
unexpected noise, please set "impedance" at "LOW" if you are connecting
a mic jack to a "low input" in the subordinate device.
If your subordinate device is with general input socket (e.g., LINE IN, AUX IN
, etc), please set "impedance" at "HI" to avoid too low volume output
"
/ EJ-702DR
-PLUS
AF OUT
,
"
.)
-PLUS
DC INPUT
12 15V/0.6A
LOW/HI
-
.
3
' "
"
DC INPUT
12 15V/0.6A
Amplifier
LOW/HI
AF OUT