Okayo Portable PA System Operating Instructions C 7206 Basic PA C 7207 PA with UHF Wireless Mic C 7210 PA with UHF Wireless Mic & MP3 Player C 7192 Wireless Handheld Microphone C 7193 Condenser Wireless Handheld Microphone C 7195A...
Page 2
Okayo Portable PA System This new release from Okayo is exclusive to Altronics. Not much larger than a shoebox and weighing just 4kg it is very compact and produces a clean crisp sound from its powerful 30W amplifier. The inbuilt battery will provide several hours of use away from mains power.
Page 3
Okayo Portable PA System Figure 1: Front 1. UHF receiver module (fitted on C 7207 & C 7210 models. Module available separately as C 7187) 2. Blanking plate for additional UHF receiver module if required. 3. Speaker. Figure 2: Rear 1.
Page 4
Okayo Portable PA System 6. 7. Figure 3: Level Adjustment & Input/Output Module 1. Master volume level 5. 6.35mm mic input 2. Tone (bass/treble) level 6. 3.5mm aux output 3. Aux input level 7. 3.5mm aux input 4. Wired mic level...
Page 5
Okayo Portable PA System Figure 5: MP3/USB Audio Player Module 1. Power button 7. Play / Pause button 2. LCD screen 8. Stop button 3. SD card slot 9. Repeat 4. Pitch control 10. Next track 5. USB socket 11. Previous track 6.
Page 6
Okayo Portable PA System Fitting Additional C 7187 UHF Wireless Microphone Receiver Module 1. Ensure portable PA is NOT connected to mains power. Disconnect all input cables. 2. Unscrew the blanking panel on the front panel (see figure 1). 3. Slide the UHF wireless microphone module in, ensuring the board slots into the connector at the rear of the empty expansion bay.
Page 7
Okayo Portable PA System before switching the microphone off automatically. 8. To turn the microphone off press the power switch for 2-3 seconds until the LCD screen displays “OFF” 9. When using with rechargeable NiMH batteries, connect a DC 5V plugpack (Altronics M 8909 or M 8909A plus M 9187 tip adaptor) to the charging port on the base of the microphone.
Page 8
Okayo Portable PA System 1. Ensure microphone is switched off before inserting batteries. 2. Remove battery clip. Insert 2 x AA batteries (alkaline or rechargeable’s are recommended). 3. Switch the top mounted power switch to ON. The power LED will illuminate red and “ON” will be displayed on the LCD screen.
Page 9
Okayo Portable PA System Figure 8: Mounting to mic stand or C 7213 wall bracket. 5/8” Threaded 5/8” Thread 5/8” Thread Microphone Stand Moulded into Moulded into Bottom of Unit Bottom of Unit C 7213 Mounting Bracket Plate & Adaptor Specfications Operating Life (fully charged) ..11 hrs (NiMH) or 14 hrs (Alkaline)
Page 10
Okayo Portable PA System Table 1: UHF Wireless Channel Guide IMPORTANT Maintenance / Operation Guidelines Avoid excessive heat: Do not leave transmitters or portable PA receiver in direct sun for extended periods, in front of heaters or any source of high temperature Avoid rough handling: Transmitter or portable PA receiver may be damaged if dropped Fully charge portable PA battery: Ensure battery is fully charged before placing into storage for long periods.